SAFETY PRECAUTIONS
The exclamation point within an equilateral triangle is intended to alert the user to presence of impor- tant operating and maintenance (servicing) instruc- tions in the literature accompanying the appliance.
SECURITE
Le point d'exclamation à l'intérieur d'un triangle équilatéral avertit l'utilisateur de la présence d'in- structions importantes d'utilisation et de mainte- nance dans la documentation accompagnant l'ap- pareil.
3 DESCRIPTION
This indoor/outdoor mounting equipment is designed for fixed camera or camera housing installations up to 9 kg (20 lb) rated load.These models are made of lightweight alu- minum and feature welded construction, providing an extremely rigid camera mount. The
SICHERHEITSVORKENHRUNGEN
Das Ausrufezeichen in dem gleichseitigen Dreieck ist dazu da, den Benutzer auf
PRECAUCIONES DE SEGURIDAD
El símbolo de exclamación dentro de un triángulo equilátero, se muestra con el objetivo de alertar al ususario de que instrucciones de operación y man- tenimiento importantes acompañan al equipo.
1 UNPACKING
Unpack carefully.This is mechanical equipment and should be handled with care.
Check for the following items:
•Verify the unit model number.
•Instructions for Use.
If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If any items are missing, notify Sanyo.The shipping carton is the safest container in which the unit may be transported. Save it for possible future use.
2 SERVICE
If the unit ever needs repair service, the customer should contact Sanyo.
4 INSTALLATION
1. Determine a secure wall mounting location.
WARNING:All mounts are designed to support a load only in a vertical direction. Mounts MUST be positioned as shown under
SPECIFICATIONS.
2. CAUTIONS:
a.For a secure installation, use four
b.If bolts are used, they should extend through the mounting surface and be secured with flat washers, lock washers, and nuts on the opposite side. Each bolt must have a minimum
c.If studs are used, they should be anchored in concrete or welded to a steel backer plate. Each stud must have a minimum pull out strength of 200 kg (450 lb).
d.If the wall mount is attached to wood or to a blind structure (with no access to the rear), each fastener must have a minimum
3.Locate the four holes or stud locations using the flange as
atemplate (four holes equally spaced on a
4.Feed wires through the large hole in the flange or through the slot on the surface where the camera housing mounts.
5.Install the mount using bolts or studs at least
6.To mount the camera or camera housing:
a.Mount camera with a
b.Mount housings with three
c.Lock mount head in position by using the supplied
2