Sanyo PLC-XL50 owner manual Part Names and Functions Rear Terminal

Part Names and Functions

Rear Terminal

q w e r

t y u i o !0

qSERVICE PORT

This jack is used to service the projector.

wCOMPUTER IN 1

Connect output signal from a computer, or RGB scart 21-pin video output to this terminal (pp.16, 18).

When the cable is of the longer variety, it is advisable to use this terminal and not COMPUTER IN 2/MONITOR OUT.

eCOMPUTER IN 2/MONITOR OUT

This terminal is switchable and can be used for input from a computer or output to the other monitor.

Set the terminal up as either Computer input or Monitor output properly. [Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1 terminal (pp. 16, 49)].

rCOMPONENT IN

Connect the component video output signal to these jacks (p.18).

tALARM buttons

Use these buttons when setting up the Alarm function (pp.55-56).

yS-VIDEO IN

Connect the S-VIDEO output from video equipment to this jack (p.17).

uAUDIO OUT(VARIABLE)

Connect an external audio amplifier to this jack (pp.16-18).

This terminal outputs sound from AUDIO IN terminal (i or !0).

i AUDIO IN COMPUTER

Connect the audio output (stereo) from a computer connected to w or e to this jack (pp.16, 18).

oVIDEO IN

Connect the composite video output from video equipment to VIDEO jack (p.17).

!0AUDIO IN

Connect the audio output from video equipment connected to r, y or o to this jack. [When the audio output is monaural, connect it to L (MONO) jack (p.17, 18).

10