Maintenance and Cleaning
Lamp Replacement
When the life of the projection lamp of this projector draws to an end, the LAMP REPLACE indicator emits a yellow light. If this indicator lights yellow, replace the lamp with a new one promptly.
This indicator is yellow when the life of the projection lamp
WARNING:draws to an end.
TURN OFF THE UV LAMP BEFORE OPENING THE LAMP COVER
Top Control
POWER | W | LAMP REPLACE |
ON | NPUT | KEYSTONE |
SELECT |
|
|
|
| + |
- |
| VOLUME |
VOLUME |
|
|
CAUTION | CAUTION |
Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.
For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp.
1 | Turn off the projector and disconnect the AC power |
| cord. Allow the projector to cool for at least 45 |
| minutes. |
2 | Remove the screw with a screwdriver, and remove |
3 | the lamp cover. |
Remove 2 screws of the lamp with a screwdriver | |
4 | and pull out the lamp by grasping the handle. |
Replace the lamp with a new one and tighten the 2 | |
| screws back into position. Make sure that the lamp |
| is set properly. Replace the lamp cover and tighten |
| the screw. |
5 | Connect the AC power cord to the projector and |
6 | turn on the projector. |
Reset the lamp replacement counter. | |
| See "Lamp Replacement Counter" on the next |
| page . |
Lamp Cover | Screw |
Screw
Lamp
Screw
Handle
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.
● Model No. of your projector | : |
● Replacement Lamp Type No. | : |
| (Service Parts No. 610 332 3855) |
54