Installation

English

1

Connect the computer's monitor output

 

terminal to the projector's input terminal with

 

the VGA cable.

 

 

 

2

Connect the Presentation Remote Receiver to
the USB port of your computer.

 

3

 

 

Install the batteries into the Remote Control

 

with following the instruction below.

Note : Read carefully the battery precautions in the projector owner's manual.

Note :

–The Presentation Remote Receiver can only be connected with a standard USB port.

–Some computer settings may have to be changed in order for the mouse function to be used. Refer to your computer's owner's manual for details.

–When switching the remote control code of the projector and the remote control, that of the presentation remote control also needs to be switched. Press and hold both the FREEZE and P-TIMER buttons together for 10 seconds or more to switch the code. (For detail, refer to the projector owner's manual.)

Presentation
Remote Control
VGA cable
Presentation Remote Receiver

30°

16.4’(5 m)

Presentation Remote

30° Receiver and Projector

Remote Receiver.

Remote Control Battery Installation

1

Remove the battery

2

Slide the batteries into

3

Replace the compartment
compartment lid.the compartment.lid.

Two AAA size batteries For correct polarity (+ and –), be sure battery terminals are in contact with pins in compartment.

To insure safe operation, please observe the following precautions : ● Use (2) AAA, SUM-4 or LR03 type alkaline batteries.

● Replace two batteries at the same time.●Do not use a new battery with a used battery.●Avoid contact with water or liquid.●Do not expose the remote control to moisture, or heat.●Do not drop the remote control.

●If a battery has leaked on remote control, carefully wipe case clean and install new batteries.

●Risk of explosion if battery is replaced by an incorrect type.●Dispose of used batteries according to the instructions.

2