Black Box ET1000A, ET0010A, ET0100A Disaster Recovery Install, Ordering of actions is important

Installation Examples

Ordering of actions is important.

You should install in the following steps:

1Power on both servers

2Assign IP to server #1

3Assign IP to server #2

4Make sure that server #1 can see server #2 on the network

5Run /etc/init.d/policyserver-install on server #1 ( same order of IP addresses on both )

6IMPORTANT: WAIT for server #1 to fully complete the install and startup

7Run /etc/init.d/policyserver-install on server #2 ( same order of IP addresses on both )

Once installation is complete you can view the web interface from either of the cluster nodes IP addresses.

To verify that the cluster is in place check the Platform -> Utilities page DB Nodes and Appserver Nodes.

Disaster Recovery Install

Using Single Server For Main Site

Main Site

•

•

Assign an IP to the Main site installation.

Modify the /opt/scripts/policyserver-init.conf and set the following. Emacs, nano, and vi are available on the OS.

NOTE

The disasterHost IP should be the IP of the Disaster Recovery server.

########################################################################

#######

#######

####### Disaster Recovery options

#######

#

##When this server will use a disaster recovery site set the following: heartbeatEnabled=true

disasterEnabled=true

disasterHost=192.168.80.X - THE IP OF THE DISASTER RECOVERY SERVER disasterUser=pserver

disasterPass=pserver

heartbeatPort=8764

#

#

##When this server IS the disaster recovery site set the following:

#disasterServer=true

#disasterServerUser=admin

#heartbeatInterval=30000

EncrypTight Manager Installation Guide 15