Sanyo SAP-KRV123EH, SAP-KRV93EH Using the Remote Control Unit, Remote Control Unit continued

Models: SAP-KRV93EH SAP-KRV123EH

1 25
Download 25 pages 39.04 Kb
Page 10
Image 10
Using the Remote Control Unit

01_SAP-KRV93EH_EN.fm Page 10 Thursday, February 12, 2004 12:10 PM

Remote Control Unit (continued)

SENSOR button

When you press this button (use a small-tipped object such as a ballpoint

 

 

 

pen), the

mark will appear at the display. And the room temperature is

 

 

 

detected by the sensor which is built into the indoor unit and the air

 

 

 

conditioner is controlled accordingly.

 

 

 

If the remote control is located near a heat source, such as a space heater or

 

NOTE

 

 

 

 

in direct sunlight, press the SENSOR button to switch to the sensor on the

 

 

 

 

 

 

indoor unit.

 

 

 

 

 

Temperature Display Selector

This switches the temperature display between °C and °F.

 

button

 

 

 

 

 

 

Time Display Selector button

This switches the time display between 24-hour time and 12-hour time.

 

 

 

 

ACL button (ALL CLEAR)

Puts the remote control unit into pre-operation status. Always press this

 

 

 

button after replacing the batteries.

 

 

 

 

ADDRESS switch

• The address switch changes to prevent mixing of signals from remote

 

 

 

control units when two air conditioners are installed next to each other.

 

 

 

Normally, the address switch is set to A. For more information, please

 

 

 

contact the dealer where you made the purchase.

 

 

 

• Normally, the tabs on the remote control unit should not be bent.

 

 

 

 

 

NOTE

The remote control unit sends the temperature signal to the air conditioner regularly at five minute intervals. If the signal from the remote control unit stops for more than 15 minutes due to the loss of the remote control unit or other trouble, the air conditioner will switch to the temperature sensor which is built into the indoor unit and control the room temperature. In these cases, the temperature around the remote control unit may differ from the temperature detected at the air conditioner’s position.

Using the Remote Control Unit

How to Install Batteries

1. Slide the cover in the direction indicated by the arrow and remove it.

2. Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the battery compartment.

3. Use a thin object such as the tip of a pen to press the ACL button.

ACL button

NOTE

The batteries last about six months, depending on how much you use the remote control unit. Replace the batteries when the remote control unit’s display fails to light, or when the remote control cannot be used to change the air conditioner’s settings.

Use two fresh leak-proof type-AAA alkaline batteries.

In replacing batteries, follow the instructions as mentioned in the sub-section “How to Install Batteries”.

If you do not use the remote control unit more than 1 month, take out the batteries.

10

OI-671-10-EG

 

Page 10
Image 10
Sanyo SAP-KRV123EH, SAP-KRV93EH instruction manual Using the Remote Control Unit, Remote Control Unit continued