Technical Specification
Input power : | 1800W |
Input voltage : | |
Protection class: | class ll |
Power cord length: | 5m |
Dust capacity : | 2L |
Trouble Shooting
If you have a problem with your cleaner, consult the handy guide as below. If the cleaner is malfunctioning, do not operate it before asking for service.
Problem |
|
| Possible Solution | ||
|
|
|
|
| |
|
|
|
| Clean the filter and clean up the inside of the dust cup. | |
Noisy operation |
| Clean or replace the filter. | |||
Low Suction |
|
| Remove the blockage. | ||
|
|
|
| Put the dust cup in place. | |
|
| Clean the filters, and clean up the inside of the dust cup. | |||
|
| Check for blockages and unblock and allow it to cool. | |||
Automatically Stopping | |||||
Plug unit firmly. | |||||
|
|
|
| ||
|
|
|
| ||
Decrease | of | the | If the vacuum power decrease, rinse the HEPA filter and | ||
vacuum power |
| the exhaust filter | |||
|
|
|
| ||
Cannot Find |
|
| Nozzle is clipped into a compartment at the bottom edge | ||
the | Combination | on the back of the vacuum cleaner (between the wheels). | |||
Nozzle |
|
|
| It is a single attachment. | |
|
|
|
|
| |
|
|
|
| Due to the strong suction power, it may be difficult to push, | |
|
|
|
| especially thick carpet. Rather than to use the floor brush | |
|
|
|
| forcibly, lift up the Floor Brush momentarily. It allows air to | |
Floor | Brush | hard | to | flow into the vacuum releasing and built up suction | |
push |
|
|
| pressure, and then do well to push floor brush. | |
|
|
|
| Slide and open the suction adjuster located on the hose | |
|
|
|
| handle grip. This will reduce suction power of the floor | |
|
|
|
| head. | |
Cord | doesn’t | fully | Pull out the cord and rewind again. | ||
rewind |
|
|
| ||
|
|
|
| ||
|
|
|
|
| |
|
|
|
| 7 | |
