Sanyo SM-GA0005 service manual Door Combination, （a） （b）

4.2THE DOOR COMBINATION

To disassemble,

1.Pull out the power plug.

2.Take off the cabinet.

3.Loosen the two six –angle screws of left hinge (up) with a socket wrench (FIG.4 - 2).

4.Push the door release button to have the hook out (FIG.4 -3).

5.Pull the hinge with the door out of the oven together, and take off the washer of the hinge (low) shaft (FIG.4 - 2).

6.Pick up the ten inverse hooks which around the

cover with a small screwdriver carefully(ATTENTION: the cover is made of plastics, and is very liable to be broken), and take out the cover.

7.Take off the two screws at the door side with a “+”-screwdriver

8.Take off the hinge (up)(FIG.4- 2).

9.Apart the doorframe from the doorplate (FIG.4-2).

door hook

10.Take off the hook spring with a pointed plier, then the hook combination.

11.Clamp the window plate with hand, push it down according to the arrow direction, and take it off.

six-angle screw

hinge(up)

oven

Fig.4-2

latch switch holder
	latch switch holder
latch switch
	latch switch
door hook
pilot switch	pilot switch

	（a）	（b）
To assemble the door combination(see sketch
4-2 to 4-5)	Fig.4-3

1.Apply proper silicon grease or lubricating

grease on the “★” mark of the hook first, then fix the hook on the oven door, and the spring on its place (FIG.4 - 5), check whether the hook is operating in normal.

2.Apply proper silicon grease or lubricating grease on the “★” mark of the hinge (UP), install the hinge (UP) in the hole at right above of the door as FIG.4 - 2, then install the window on the door as FIG.4 - 1, make sure the hook won’t out. Then tighten each hook on the window to the trough of the door. After assembled, check whether the door hook is working in normal.

3.Tear off the back protective paper of the window, then the sides of adhesive tape as FIG.4 – 1, and stick it on the window, Tear three right sides protective paper about 10mm, and fix the window in the doorframe as

12