1.Assemble the fan motor as FIG.4 – 14. Drip the glue on the “★”place of the fan motor shaft, and fix the fan on the motor, make sure it must be fixed to the bottom of the shaft. Attention: The fan motor shaft should not be curved, the fan should have no abnormal stick up. After assembled, check whether the running fan would knock the fan holder.
2.Assemble the fan holder as FIG.4 – 13, Then connect the power supply cord with the two wires of the fan motor, and tighten the screws as FIG.4 – 11 and FIG.4 – 12.
earthing screw
fuse housing
power supply cord
fan
fan motor back board
Fig.4-13
4.7THE CAPACITOR.
Firstly, do as the 1, 2, 3, steps of Ⅲ of this part. To disassemble,
Fig.4-14
screw
1.Pull the wires of the capacitor out
2.Loosen and take out the screw which fix the capacitor clip with a “+” – screwdriver, and take out the clip and the capacitor.
To assemble,
1.Place the capacitor in the capacitor clip with the end which have three foot near the diode
2.Insert one end of the clip in the fan holder trough
3.Tighten the screw, which fix the capacitor clip.
4.Plug in all the plugs of the capacitor.
capacitor | fan holder |
diode | screw |
|
4.8THE DIODE.
Firstly, do as the 1, 2, 3, steps of Ⅲ of this part. To disassemble,
magnetron
H.V.fuse
transformer
capacitor
1.Pull out the diode plug, which plugged in the capacitor.
2.Loosen the screw, which fixed the diode, and take the diode off.
To assemble,
diode
15
