Assembling the Outdoor Housing
●For the
●This housing is used in combination with a dome cover (clear/smoked) and a mounting bracket (wall/ pendant) that are sold separately.
☞For how to install an assembled housing, refer to the instruction manual for the bracket used. Also refer to the instruction manual for each associated device.
1.Attaching the dome cover
1Hook the safety wire (A) of the dome cover on hook hole (A’) located inside the housing.
2Connect the heater cable (B) to the heater terminal (B’) and the fan cable (C) to the fan terminal (C’).
C
A
B
B’ | Dome Cover: | |
A’ | • | |
• | ||
C’
2.Mounting the power board unit
1Pass the supplied screws 
through power board unit screw holes (D) and fasten them loosely using washers 
(4 places).
2Mount the power board unit in the housing aligning the arrows (E) of the same color (blue) on them, and then firmly tighten the screws 
loosely fastened in the previous step.
•Make sure the terminal (F) and its cable are located along the inner lateral face of the housing.
•Pull the video cable led from the ceiling or wall toward the power board unit.Power Board Unit: | D | Video cable |
D | D | D |
| a | |
| E; Blue |
| b |
|
| |
|
| F |
☞For details, please refer to “Outdoor Type” in the Mounting Bracket Instruction Manual.
3. Connecting cables
1Connect the 24 V AC power cable to the terminal (F).F
2Connect other cables to the power board unit.☞For details, please refer to “Connections and Settings” in the Installation Manual that comes with the camera unit.
4.Mounting the camera unit
1Fasten the camera unit safety wire (G) to the hook (G’) inside the power board unit.
2Align the arrows (E) of the same color (blue) on the camera unit and the housing inner face, and push
the camera until you hear a click.3Remove the plastic cover (H) of the camera unit.4Attach the dome cover by fastening 4 screws (J) using the supplied hexagonal wrench.
G’
G
E; Blue
*
J
*
H J 
J
* To remove the camera unit
J
2