Sanyo VCC-3944 MANU, ATW, INT, ATW, MANU, PHASE, PHASE, PHASE, CAUTION:, ■Line phase adjustment, ■White balance adjustment

SETTINGS

■White balance adjustment 5

Normally the switch 5 is set to the down (ATW: auto white balance) position and the white balance is adjusted automatically. If a manual white balance adjustment is necessary, follow the steps below.

Set the switch 5 to the up (MANU) position, then adjust the color.

• Turn R to set the red ratio and/or B to set the blue ratio.

MANU

R WB B

ATW

■Line phase adjustment 6

When using a camera switcher to connect 2 cameras or more to one monitor, there may be a vertical roll of the images when switched. In such a case, set as described below.

1 Set the switch 6 to the up (LL) position.

2 Switch the display on the monitor from camera 1 to camera 2.

Adjust the Line PHASE volume on camera 2 until the vertical roll of the image stops.

If more than two cameras are used, please repeat this procedure for all the cameras.

LL

INT

CAUTION:

If the vertical roll cannot be corrected by setting the Line PHASE volume on camera 2, try setting the Line PHASE volume on camera 1. If it still cannot be corrected, please check that the polarity of the power cords of all connected devices is correct.

12 English