Sanyo VCC-3944 lock screw, ■Pin layout, flange-back, flange-back, flange-back, DC type lenses, adjustment dial, lock screw (M2:+), ■Flange-backadjustment

MOUNTING THE LENS

21

43

3

2

1

■Pin layoutDC type lenses

1Brake coil (–)

2 Brake coil (+)

3 Drive coil (+)

4 Drive coil (–)

■Flange-back adjustment

If the pick-up surface is not correctly positioned with relation to the lens focal point, the picture will be out of focus (in particular when using auto-iris power zoom lenses, sold separately). If that is the case, adjust the flange-back position as described below.

1 Using a + screwdriver, loosen the flange-back lock screw (M2:+).

2 Set the zoom lens to the maximum telephoto position, set the focus using the focus ring on the lens.

3 Set the zoom lens to the maximum wide angle position, set the focus using the flange-back adjustment dial.

4 Repeat steps 2 and 3, until the image stays in focus when changing from a telephoto shot to a wide angle shot. When the setting is complete, tighten the flange-back lock screw.

English 7