Parts Names and Functions
■Rear
| ② | ⑤ | ⑤ Lens terminals | |
① | ⑥ VIDEO OUT connector (BNC type) | |||
| ||||
|
| Used to output image signals. | ||
|
|
| Connect to video equipment such as a | |
|
|
| monitor. |
④
POWER VIDEO OUT
ALARM OUT ALARM IN
⑥
⑦ Control terminals |
When connecting the cable, press and hold |
down the protrusion of the terminal, insert the |
AC24V
DC12V
③
GND
LINK
COM
LAN
⑦
⑧
cable into the terminal, and then release the | |
protrusion. | |
• | COM terminal (Earth terminal) |
• | ALARM IN terminal |
| Connect to a device such as an external |
CLASS 2 WIRING
⑨
①Flange back fixing screw
②Flange back adjustment lever
③AC24V / DC12V terminals
Connect this terminal to the power supply.
•When the camera is turned on, the POWER lamp lights.
④Power lamp
alarm switch or an infrared sensor. |
• ALARM OUT terminal |
Used to connect to an external buzzer or |
lamp. |
When an alarm is detected, the device |
connected to the terminal notifies that an |
alarm is detected. |
⑧LAN connector
Used to connect the camera to your network.
⑨LINK lamp
When connected correctly to the network, the lamp will illuminate 3 seconds after the power is turned on.
Flashes while data is being transferred.
■Side
② 
③
①
④
①Camera setting switches (P7)
②White balance manual adjustment controls
R:Red adjustment
B:Blue adjustment
③Iris adjustment control (LEVEL)
This can only be adjusted when using a DC- type automatic iris lens.
④Reset button (RESET)
If pressed for approximately 5 seconds, it initializes the various NETWORK SETTINGS settings (such as IP address) for network operations.
5
