CAUTIONS CONCERNING THE DOCKING STATION AND AC ADAPTOR/

CHARGER

DANGER

Do not recharge a battery pack other than the specified battery pack

Recharging a dry-cell battery or other type of rechargeable battery may cause excess heat, combustion, or leakage, and cause a fire, injuries, burns, or damage to nearby objects.

Concerning the power cord

The voltage rating for the power cord supplied with this camera conforms to the standards of the country in which the camera was sold.

Do not get the docking station or AC adaptor/charger wet

Make sure they do not get wet, as doing so may cause a fire or electric shock.

Do not use them in a bathroom.

If the docking station or AC adaptor/charger gets wet, immediately unplug it from the power outlet and remove the battery pack. Then contact the place of purchase. If used while wet, it may cause a fire, electric shock, or an accident.

WARNING

Cautions when plugging in the power cord

Securely plug the power cord all the way into the power outlet. If the docking station or AC adaptor/charger is used with the power cord not fully plugged in, heat may be generated and cause a fire.

Do not use if the power cord is damaged or cannot be correctly plugged into the power outlet. Using in this condition may cause a fire or electric shock.

Do not allow dust, etc., to build up on the power cord or power outlet. A build-up of dust may cause a short circuit or generate heat and cause a fire. Use a dry cloth to remove dust or dirt build-up after unplugging the cord from the power outlet.

When unplugging the power cord, be sure to hold the plug part and slowly pull it out of the power outlet. Pulling the cord portion may damage the power cord and cause a fire or electric shock.

Do not damage the power cord

Do not place heavy objects on the power cord. Do not place the power cord near a heat source. Do not excessively bend the power cord, modify it, or secure it with staples. Doing so may damage the power cord and cause a fire or electric shock.

If the power cord is damaged, or if it does not plug properly into the docking station, AC adaptor/charger or wall outlet, contact the place of purchase.

Cautions concerning the power cord

Do not leave the power cord plugged into an electrical outlet while the other end is not plugged into the AC adaptor/charger. The loose end can cause electrocution if touched with wet hands or if handled by children.

Use only the supplied power cord. If a different power cord is used, it may be rated for a different current load, and that may cause a fire.

The supplied power cord is for exclusive use with the AC adaptor/charger supplied with your camera. Do not use it with other devices, as doing so may cause a fire or electric shock.

Do not use a bundled power cord, as the heat generated may cause a fire.

Do not touch the power cord plug with wet hands

Doing so may cause an electric shock.

CAUTION

Do not hold the hot part for a long time

The device(s) may become warm during use. A low temperature burn may result if you hold the hot part for a long time.

Do not place on an unstable surface

If may fall, resulting in damage or injury.

If the device has fallen or has been trampled on, and its body is damaged, turn it off, remove the battery, and take it to the dealer for repair. Using the device after its body has been damaged may cause a fire or electric shock.

70



Page 71
Image 71
Sanyo VPC-E2100 instruction manual Concerning the power cord, Do not get the docking station or AC adaptor/charger wet, 70