MECHANICAL SPECIFICATIONS
Model Number | Window Type |
| Trim Ring Color | |
|
|
|
|
|
Dome, Smoked |
| Black | ||
|
|
|
|
|
Dome, Smoked |
| White | ||
|
|
|
|
|
Flat, Smoked |
| Black | ||
|
|
|
|
|
Flat, Smoked |
| White | ||
|
|
|
|
|
|
|
|
| |
Model Number | Maximum Camera and Lens |
| Weight | |
|
|
|
| |
7.5 L x 3.0 W x 3.0 H in |
| ~2 lbs. (0.9 kg) | ||
(190 x 76 x 76 mm) |
| |||
|
|
| ||
|
|
|
| |
7.5 L x 3.0 W x 3.0 H in |
| ~2 lbs. (0.9 kg) | ||
(190 x 76 x 76 mm) |
| |||
|
|
| ||
|
|
|
| |
5.2L x 3.0W x 3.0H in |
| ~2 lbs. (0.9 kg) | ||
(132 x 76 x 76mm) |
| |||
|
|
| ||
|
|
|
| |
5.2L x 3.0W x 3.0H in |
| ~2 lbs. (0.9 kg) | ||
(132 x 76 x 76mm) |
| |||
|
|
| ||
|
|
|
|
|
Note: A right angle BNC is recommended
Camera Mounting:
A
Window: Lightly tinted acrylic.
Construction: Housing is constructed of aluminum. The lower domed window has a
4 INSTALLATION
Attention: Installation should be performed by quali- fied service personnel only, in accordance with the National Electrical Code or applicable local codes. Refer to applicable installation section.
4.1Suspended Ceiling Mounting
CAUTION:These units must be properly and securely mounted to a supporting structure capable of sustaining the unit weight. Use care when selecting mounting hardware (not supplied) for installation The mounting surface and unit's weight should be carefully considered.
Mount the unit in a suspended ceiling grid using the existing ceiling tile as follows:
1.Remove tile at desired location
2.Move adjacent tiles for access as required.
3.Cut a 172 mm (6.75 in) diameter hole in the center of the tile. Use two pencils (or a pencil and a nail) with the tem- plate tool provided to draw the circle.
4.Install box into
Figure 1
5.Pull the drawstring tight (away from the screw) and lock into groove. DO NOT CUT DRAWSTRING Push the excess string through the hole provided. As an option, a screwdriver may be used to turn screws and lock ceiling clamps in place.
6.Reinstall tile in grid.
7.Fasten support wire (not provided) to structural framing, masonry, or concrete above the unit. Connect the other end to the eyebolt in the top of the box. Draw wire tight and twist securely.
8.Run the electrical cable into the housing through the con- duit as required by applicable codes.
9.Complete the electrical connections.
10.Adjust camera bracket to proper angle and mount camera to camera bracket. See Figure 2.
Figure 2
11.Assemble dome in the trim ring by lining the slots in the dome with tabs in the trim ring. Push one side of the dome under the tab; the other side should clear the other tab. Turn the dome to secure it.
4