12.Attach the dome/trim ring by lining up the dots on the box and the trim ring. Push on one side of the trim ring near the the flat section of the box, then push on the other side of the trim ring until it snaps into place. Listen for a distinct click to ensure ring is securely in place. See Figure 3.
Figure 3
13.Adjust the dome so that the viewing slot is in the proper position.
14.Replace any previously removed adjacent tiles.
4.2Hard Ceiling Mounting
Mount the unit in a hard ceiling, e.g. dry wall etc. as follows. Be sure the ceiling will support the weight of the housing and camera.
1.Cut a 172 mm (6.75 in) diameter hole in the ceiling. Use two pencils (or a pencil and a nail) with the template tool provided to draw the circle.
2.Run the electrical cable into the housing through the con- duit and the hole in ceiling as required by the applicable codes.
3.Install box into
Figure 4.
Figure 4
4.Pull the drawstring tight (away from the screw) and lock into the groove. DO NOT CUT DRAWSTRING Push the excess string through the hole provided. As an option, a screwdriver may be used to turn screws and lock ceiling clamps in place.
5.Complete the electrical connections.
6.Adjust camera bracket to proper angle and mount cam- era to camera bracket. See Figure 5.
Figure 5
7.Assemble dome in the trim ring by lining the slots in the dome with tabs in the trim ring. Push one side of the dome under the tab; the other side should clear the other tab. Now turn the dome to secure it.
8.Attach the dome/trim ring by lining up the dots on the box and the trim ring. Push on one side of the trim ring near the the flat section of the box, then push on the other side of the trim ring until it snaps into place. Listen for a distinct click to ensure ring is securely in place. See Figure 6.
Figure 6
9.Adjust the dome so that the viewing slot is in the proper position
5
