CHARACTER PITCH
FIXED PROP
This selection allows you to set the default character pitch to
either fixed character spacing or proportional character
spacing.
1. Use the LINE key to step the cursor to the desired setting.
2. Once the correct setting is highlighted, pressing the FEED
key will accept the setting and the display will return to the
Advanced Mode display.
Note: This command can be overriden by the <ESC>PR or
<ESC>PS Character Pitch Commands.
ADVANCED MODE To exit the Advanced mode, power the printer off and then
back on.
CARD MODEThe Card Mode allows the operator to manage the Expanded Memory (PCMCIA Cardor Internal Expanded Flash ROM).
ADVANCED MODE The Card Mode is entered from the Advanced Mode display
by pressing the LINE key once.
CARD MODE The Card Mode display indicates that the printer is in the Card
Mode. To advance to the first selection, press the FEED key.
MEM SELECT (CC1)
CARD MEMORY
This selection determines which type of optional expanded
memory will be addressed as “CC1" in the command
streams.The CARD selection specifies the optional PCMCIA
card as CC1 and the optional Expanded Flash ROM as CC2.
The Memory selection specifies the optional Expanded Flash
ROM as CC1 and the optional PCMCIA card as CC2.
1. Step the cursor to the desired selection using the LINE
key.
2. Once the cursor is positioned over the desired selection,
press the FEED key to accept the selection and advance
the display.
CARD->MEMORYCOPY
TRUETYPEFONT Y/N
This selection allows you to copy TrueType fonts from the
PCMCIA Memory card installed in the Memory Card slot on
the rear of the printer to the optional Flash ROM.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the Card to
Memory SATO Font Copy mode.
COPY START
YES NO
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
TRUETYPEFONTCOPY
COPYING
3. Press the FEED key to accept the selection. If Yes was
selected the copy process will start.
TRUETYPE FONTCOPY
COMPLETED
4. Once the copy process is completed, press the FEED key
to step the display.
SATO CL Series “e” Printers PN 9001074 Rev. B Page 3-15
Section 3. Configuration