Scag Power Equipment GC-STC-CSV 4, FIGURE 3-5, FIGURE 3-6

12. Install the hopper mounting brackets to the

outside of the frame on the rear of the machine.

See Figure 3-5.

FIGURE 3-5

13. With help from an assistant, install the hopper

assembly to the machine by installing the

mounting post into the hopper mounting brackets

and secure with the ring pins. Tighten the bolts

and jam nuts. See Figure 3-6.

FIGURE 3-6

Figure 4 A GC-STT Install Art

Hopper

Mounting

Brackets

Rear Frame

PROPERLY

SERVICE

ENGINE

WITH

OIL

AND

FUEL.

7. Install the blower assembly to the mounting

bracket and secure with the mounting pin.

See Figure 3-4.

8. Align the blower assembly with the discharge

opening of the cutter deck. Tighten the

hardware for the mounting bracket. See Figure

3-4.

9. Install the quick pin through the rear hole in the

discharge chute mounting bracket. See Figure 3-

FRONT SIDE

IDLER PULLEY

BACK SIDE

IDLER PULLEY BLOWER

PULLEY

SPINDLE

PULLEY

10. Install the belt to the spindle pulley. When

replacing the belt, see figure below.

FIGURE 3-4

11. Install the new belt covers and secure. See

items number 1 and number 21 on page 10 of the

Blower Mounting Components section in the

Illustrated Parts List for proper installation.

RIGHT SIDE OF

CUTTER DECK SHOWN

(Note: Some parts not shown for viewing purposes.)

2006 GC-STC-V install art 3

BLOWER

ASSEMBLY

MOUNTING

BRACKET

MOUNTING PIN

TIGHTEN MOUNTING

BRACKET HARDWARE

HAIR

QUICK

Locking

Bolts

Locking

Bolts

Ring Pins

Hair