Scag Power Equipment GC-STWC-61V operating instructions Grass Catcher Removal Instructions

17.Install one 7/16-14 x 1-3/4" hex head bolt into each of the four mounting holes in the weight support bar, and through the matching holes in the caster support weldment. Secure this assembly to the front of the machine using the 7/16 - 1/2" x 1-1/4" x .083" flatwashers, and the 7/16-14 elastic stop nuts. Torque hardware to 59 ft. lbs. See Figure 3-8.

FIGURE 3-8

18. Operate and test.

4.1GRASS CATCHER REMOVAL INSTRUCTIONS

1.Prepare the machine so there is easy and safe access to the work area. Remove the key and maintain all safety related work procedures.

Always wear eye and hand protection.

2.Remove the bag assemblies from the grass catcher.

3.Remove the rubber strap holding the adapter to the blower assembly and the large quick pin securing the blower to the discharge mounting bracket. See Figure 4-1.

4.Remove the belt, pin, hair pin and large quick pin securing the blower assembly to the cutter deck and remove the blower assembly. See Figure 4- 1.

ADAPTER

BLOWER

ASSEMBLY

QUICK PIN

PIN & HAIR PIN

MOUNTING

BRACKET

RIGHT SIDE OF

CUTTER DECK SHOWN

2006 GC-STC-V removal art 1

(Note: Some parts not shown for viewing purposes.)

FIGURE 4-1

5.Loosen the locking bolts and remove the two (2) pins holding the hood assembly to the mounting posts on the rear of the machine. See Figure 4-2.

Loosen

Locking

Bolts

Remove Pins

Loosen

Locking

Bolts

Remove Pins

FIGURE 4-2

6.With help from an assistant, remove the hood assembly.

4