Scag Power Equipment SE-3.5BS Setup & Operation, n Protect Operators, n Assembly, Handle Setup

SAFETY AND OPERATING

INSTRUCTIONS (CONT'D)

nProtect Operators

1.Keep a safe distance between two or more operators when working with a cutting crew at the same site.

SETUP & OPERATION

nAssembly

1.Install the upper handle assembly with hardware as shown in Figure 3 using (4) 5/16-18 x 1" bolts, and (4) 5/16-18 elastic stop nuts.

2.Attach the height adjustment index to the upper handle assembly using (2) 5/16-18 x 1-1/2" hex head bolts, (2) 5/16 flat washers and (2) 5/16-18 elastic stop nuts.

3.Install the tube-type control rod on right hand side between the front wheel height lever and the index quadrant using (4) hair pin cotters to secure the control rod.

4.Install the operator presence safety control rod with the long rod at the top and the short rod at the idler pulley arm using (4) hair pin cotters.

Adjust the length of the rod for normal belt tension (See Figure 4).

5.Fill the engine with oil as described in the engine operator's manual. Lubricate all grease fittings with lithium-based grease.

6.Fill the engine fuel tank with fresh unleaded gasoline that has a minimum octane rating of 87.

Operator presence shown separated for illustration purpose only.

Figure 3, Handle Setup

Figure 4, Operator Presence Controls

4