Scag Power Equipment STT61V-31EFI-SS Operating Instructions, Section, 1. Controls and Instruments

R

Section 4

OPERATING INSTRUCTIONS

CAUTION

Do not attempt to operate this mower unless you have read this manual. Learn the location and purpose of all controls and instruments before you operate this mower.

4.1Controls And Instrument Identification

Before operating the mower, familiarize yourself with all mower and engine controls. Knowing the location, function and operation of these controls is important for safe and efficient operation of the mower.

1.Ignition Switch (Figure 4-1). The ignition switch is used to start the engine and has three positions; OFF, ON, and START.

2.Mower Deck Switch (Figure 4-1). Used to engage and disengage the mower drive system. Pulling up on the switch will engage the deck drive. Pushing down on the switch will disengage the deck drive.

3.Engine Throttle Control (Figure 4-1). Used to control the engine speed. Pushing the lever forward increases engine speed. Pulling the lever back decreases engine speed. Full back position is the IDLE position. Full forward is the cutting position.

4.Volt Meter (Figure 4-1).Indicates the condition of the charging system. When the engine is running the needle should be toward the positive end of the meter. If the needle is toward the negative end of the meter, this indicates a discharge condition and the machine should be taken in for service.

WATER TEMPERATURE

MOWER DECK

SWITCH

VOLT METER

IGNITION SWITCH

LEFT STEERING

CONTROL

PARKING BRAKE

CONTROL

ENGINE THROTTLE

CONTROL

CHECK

ENGINE

LIGHT

FUSES

DUMP VALVE

DECK LIFT

RIGHT STEERING

CONTROL

CUTTING HEIGHT

ADJUSTMENT

DECK RELEASE

SEAT BELT

FUEL GAUGE

DUMP VALVE

HOUR METER 2008 STT-EFI CHMI

Figure 4-1. Controls and Instruments

12