CUSTOM-CUT BAFFLE ADJUSTMENT

The Custom-Cut Baffle is designed to deliver optimum airflow and superior cutting performance in any type of grass. The Custom-Cut Baffle can be raised or lowered to precisely tailor the deck's performance for the type of grass being cut. The baffle can be set in three (3) different positions for optimum performance.

A.3" Position - baffle is installed using the top set of holes on the front baffle welded inside the cutter deck. (See Figure 10). The Advantage cutter deck will deliver the best quality-of-cut in very tall, wiry, tough to cut grass.

B.3-1/2" Position (factory setting) - baffle is installed using the middle set of holes on the front baffle welded inside the cutter deck. (See Figure 11). For general purpose cutting, place the Custom Cut Baffle in the 3-1/2" position. This gives the best mix of cutting performance in all types of grass.

C.4" Position - baffle is installed using the bottom set of holes on the front baffle welded inside the cutter deck. (See Figure 12). Placing the baffle in the 4" setting will enhance fall cutting (leaf pickup) and reduce cutter deck "blowout".

TO ADJUST THE CUSTOM-CUT BAFFLE HEIGHT:

1.Remove the hardware securing the Custom-Cut Baffle to the cutter deck (See Figure 9).

-NOTE-

Hardware location used in the illustrations are for reference only. Location of hardware may vary depending on the cutter deck size.

2.Move the Custom-Cut Baffle to desired position. (See Figures 10 through 12 for position)

3.Reinstall the mounting hardware as shown. (See Figures 10 though 12). Torque hardware to 39ft.lbs.

TOP SET OF HOLES

CARRIAGE BOLT

FOR 3" SETTING

 

2004 CCB - 3" Setting

ELASTIC STOP

NUT

Figure 10. 3" Custom-Cut Baffle Position

MIDDLE SET OF HOLES

CARRIAGE BOLT

FOR 3-1/2" SETTING

 

2004 CCB - 3-1/2" Setting

ELASTIC STOP

NUT

Figure 11. 3-1/2" Custom-Cut Baffle Position

BOTTOM SET OF HOLES

CARRIAGE BOLT

FOR 4" SETTING

 

2004 CCB - 4" Setting

MOUNTING HARDWARE

ELASTIC STOP

MOUNTINGNUT HARDWARE

Figure 12. 4" Custom-Cut Baffle Position

2004 CCB

Figure 9. Custom-Cut Baffle

12

Page 16
Image 16
Scag Power Equipment SW manual CUSTOM-CUT Baffle Adjustment, To Adjust the CUSTOM-CUT Baffle Height