SC407G
Figure 6. Blade Spacers
CUTTER BLADES
Do not sharpen beyond 1/3 of the width of the blade. (See figure 7)
Dress the blade with a file. Using a wheel grinder may burn the blade. Check the balance of the blade. If blades are out of balance, vibra- tion and premature wear of spindle assembly can occur. See your authorized Scag dealer for blade balancing or special tools, if you choose to balance your own blades.
ANGLE BLADE BACK
DO NOT CUT IN 
| X MUST NOT EXCEED | |
30 | 1/3 BLADE WIDTH | |
SC4O8G | ||
|
Figure 7. Blade Sharpening
NEUTRAL ADJUSTMENT
1.Raise the drive wheels off the ground and block the caster wheels.
2.Remove the speed control spring and the steer- ing control rod from the machine. (See figure 8)
Steering Control
Rod
Bolts
Spring | Bellcrank |
| Handle |
| SC160G |
Figure 8. Neutral Adjustment
3.Loosen the wing nut and let the speed adjust- ment bearing lever fall away from the cam.
4.Start the engine and observe the drive wheels. If the drive wheels are rotating, loosen the bolts on the neutral adjustment handle and move the handle up or down until the wheels are in neutral. (See figure 8)
5.Tighten the bolts on the neutral adjustment handle. When tightening the bolts, hold the bellcrank to prevent it from moving and throw- ing off the neutral adjustment.
6.Turn the engine off.
7
