- 45 -
www.SCEPTRE.com
SCEPTRE X405 User Manual
Troubleshooting

The following table contains the common problems and the solutions to these

problems. Please check this list before you contact the technicians.

Problems Solutions
Connect power cord correctly.
Turn on power.
Connect video cable correctly.
NO PICTURE
Select the input signal source with proper cable connection with
the source button.
ABNORMAL
COLORS
Match the colors on the cables to the ports off the back of the
television. I.E. red cable to red colored port.
PICTURE IS TOO
DARK
Adjust your contrast, brightness and lamp settings from the
OSD Menu. For adjust controls, refer to page 28.
Make sure you have connected both your video and audio
cables.
AUDIO ONLY NO
PICTURE
The TV’s tuner signal must not be lower than 65 %.
Make sure the audio cable is connected.
Readjust your volume via the remote control.
PICTURE ONLY NO
AUDIO
The TV’s tuner signal must not be lower than 65 %.
Turn off the TV, unplug it from the socket. Remove the
batteries out of the remote for 30 seconds. Press the remote
buttons and the power button randomly for a good 2 seconds,
and then reinstall the batteries. Try the remote to see if it
works. For battery removal instructions, refer to page 17.
REMOTE CONTROL
DOES NOT WORK
The TV’s remote sensor is also housed in the same place as
the power indicator light. Please make sure there is line of sight
from the remote control’s front sensor to the remote sensor of
the TV.
CANNOT RECEIVE
SUFFICIENT
CHANNELS
THROUGH THE
ATSC/NTSC TUNER
The TV’s tuner signal must not be lower than 65 %. Change
the direction of your antenna and rescan your channels. If you
have cable services call up your cable company and ask about
signal strength of your local cable.
Please adjust your picture setup and make sure the saturation
and the RGB are not turned all the way down. For adjustment
controls refer to page 28.
NO COLOR
The TV’s tuner signal must not be lower than 65 %. Check your
signal.
WEAK SIGNAL OR
NO PROGRAM
SYMBOL ON
SCREEN
The TV’s tuner signal must not be lower than 65 %. Change
the direction of your antenna and rescan your channels. If you
have cable services call up your cable company and ask about
signal strength of your local cable.