Schumacher Electric Corporation
Model
OWNER’S MANUAL
Instant Power™ Jump Starter & DC Power Source
THIS PRODUCT HAS A SEALED
IMPORTANT SAFETY INSTRUCTIONS
Save these instructions
important safety instructions
Someone should be within range of your voice or close enough to come to your aid when you are working near a
Have plenty of fresh water and soap nearby in case battery acid contact skin, clothing, or eyes. If acid enters the eye area, rinse with cold water for at least 10 minutes and get medical help immediately.
Do not smoke, or use matches or cigarette lighter, or allow any spark or flame near the battery or engine.
Never operate the power source unit if it has damaged lead wire or clamps. Have the lead wire replaced by a qualified technician.
Wear complete eye and clothing protection when working with
Do not permit the internal battery in the
*NOTE: In the rare case of
a
LED INDICATORS
To check the internal battery’s charge status, press the red button on the front of the
The LED lights will indicate the charge level as follows:
1.A red LED indicates a 50% or less charge and you should immediately recharge the
2.A yellow LED indicates a 50 to 75% charge. The
handling warning
WARNING: Handling the cord on this product or cords associated with this product, may expose you to lead, a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
Operating Instructions
Warning: Failure to follow instructions may cause damage or an explosion. Read entire instruction manual before use.
1.Turn ignition OFF before making cable connections.
2.Use in a
3.Keep clear of fan blades, belts, pulleys and other parts that may cause injury.
4.NEVER allow clamps to touch together or to contact the same piece of metal to prevent sparking.
5.Clamp the red clamp (+) to the positive terminal of the battery. (For a negative grounded system.)*
6.Clamp the black clamp
7.You can now crank the engine. If the engine does not start within
8.After the engine starts, first disconnect the black clamp
9.Recharge the
3.A green LED indicates the internal battery is fully charged. CHARGING of internal battery with
After removing the
1.To charge, plug extension cord into charger plug on the side of the
2.Plug the extension cord into 110V AC electrical wall outlet.
3.The red LED will glow while charging.
4.The green LED will glow when the battery has reached full charge. The green LED will glow when the battery has reached full charge. This could take up to 72 hours on some charges due to age and condition of the battery. The charger will automatically drop into a float mode and maintain the battery at full charge without damaging the battery. The
5.Recharge
MULTI-PURPOSE POWER SUPPLY
The
