Schumacher PI-1000 owner manual Inverter Features, Volt Power Cord One pair

1.10Only connect the power inverter to a 12 volt battery or power supply. Do not attempt to connect the inverter to any other power source, including an AC power source. Connecting to a 6 volt or 16 volt battery will cause damage to the inverter.

1.11Make sure the AC plug is tight.

1.12Do not modify the inverter in any way including cables, plugs, switches or AC receptacles as it may result in property damage or personal injury.

1.13Incorrect operation of the inverter may result in property damage or personal injury.

The inverter output is 120V AC and can shock or electrocute the same as any ordinary household AC wall outlet.

1.14To reduce the risk of electric shock, disconnect the inverter from the power source before attempting any maintenance or cleaning. Simply turning off the controls will not reduce this risk.

1.15Do not operate the inverter with damaged cables; have the cables replaced immediately by a qualified service person. (Call customer service at: 1-800-621-5485.)

1.16Do not operate the inverter if it has received a sharp blow, been dropped or otherwise damaged in any way; take it to a qualified service person. (Call customer service at:

1-800-621-5485.)

1.17Do not disassemble the inverter; take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or electric shock. (Call customer service at: 1-800-621-5485.)

1.18Working in the vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal battery operation. For this reason, it is of utmost importance that you follow the instructions each time you use the inverter.

1.19This inverter employs parts, such as switches and circuit breakers, that tend to produce arcs and sparks. If used in a garage, locate this inverter 18 inches (46 cm) or more above the floor level.

1.20Do not use the inverter with a product that draws a higher wattage than the inverter can provide, as this may cause damage to the inverter and product.

2.INVERTER FEATURES

1.ON/OFF Rocker Switch – Turns the inverter ON and OFF.

2.LED Indicator Light – (Green = power ON, Red = Overload/Interruption in power.)

3.12-Volt Power Cord – One pair.

4.120V AC Outlet – Two Standard (Model PI-1000) Two GFCI (Model PI-1500).

5.High-Speed Cooling Fan(s) – Keeps the inverter cool. The speed of the fan is faster as the load increases. The fan does not run when the inverter is turned OFF.

6.Analog Output Power Display – Shows 120V AC continuous power consumed. Five lights indicate half of the continuous output power and 10 lights indicate full continuous power consumption. When the inverter is OFF, the lights do not illuminate.

7.Positive Battery Cable Terminal (Red) – Accepts Positive connector cable.

8.Negative Battery Cable Terminal (Black) – Accepts Negative connector cable.

9.Ground Terminal – Grounds inverter to reduce electrical shock.

10.Thermal Protection – When the inverter case becomes hot (exceeds 145° F), the inverter shuts down until it cools off an then automatically restarts.

11.Surge Protection – When the power input from the vehicle’s battery exceeds 15 volts, the inverter shuts down. Once the voltage drops down to less than 14, it automatically restarts.

12.Low-Battery Protection – When the power input from the vehicle’s battery drops to approximately 10 volts, the inverter shuts down.

• 2 •