Schumacher PI-140 owner manual Inverter Features, Before Using Your Power Inverter

1.8Do not place the inverter on or near heating vents, radiators or other sources of heat or flammable materials.

1.9Do not place the inverter in direct sunlight. The ideal air temperature for operation is between 50° and 80°F.

1.10Only connect the power inverter to a 12 volt battery or power supply. Do not attempt to connect the inverter to any other power source, including an AC power source. Connecting to a 6 volt or 16 volt battery will cause damage to the inverter.

1.11Make sure the AC plug is tight.

1.12Do not modify the AC receptacle in any way.

1.13Do not try extending or otherwise changing the 12 volt power cord supplied with your inverter. Make sure the cord connections are tight.

1.14Incorrect operation of your inverter may result in damage and personal injury.

The inverter output is 120V AC and can shock or electrocute the same as any ordinary household AC wall outlet.

1.15Do not use the inverter with a product that draws a higher wattage than the inverter can provide, as this may cause damage to the inverter and product.

1.16Do not open – No user serviceable parts inside.

1.17This device does not include an internal Ground Fault Circuit Interrupter (GFCI).

2.INVERTER FEATURES

1.LED Indicator Light (Green = Power ON)

2.Standard Electrical 120V AC Outlet

3.12 Volt Power Plug

4.USB Power Port

5.Low-Battery Protection

3.BEFORE USING YOUR POWER INVERTER

NOTE: This inverter is designed to be used with a single battery, up to group 31 type (130 Ah or smaller in size).

NOTE: Do not use the inverter with a product that draws a higher wattage than the inverter can provide, as this may cause damage to the inverter and product.

When you turn on a device or a tool that runs on a motor, the device basically goes through two stages:

1.Start Up – Requiring an initial surge of power (commonly known as the “starting or peak load”).

2.Continuous Operation – Power consumption drops (commonly known as the “continuous load”).

The wattage (WATTS) or amperes (AMPS) can normally be found stamped or printed on most devices and equipment, or in the user’s manual. Otherwise, contact the manufacturer to find out whether the device you want to use is compatible with a modified sine wave.

• 3 •