13.maintenance instructions
13.1Before performing maintenance, unplug and disconnect battery charger
(see sections 6.7 and 7.6).
13.2After use, unplug charger and use a dry cloth to wipe all battery corrosion and other dirt or oil from terminals, cords, and the charger case.
13.3Servicing does not require opening unit, as there are no
14.storage instructions
14.1Store charger unplugged, in an upright position. Cord will still conduct electricity until it is unplugged from outlet.
14.2Store inside, in a dry, cool place (unless you’re using an
14.3Do not store clips on the handle, clipped together, on or around metal, or clipped to the cables.
15.troubleshooting
PROBLEM | POSSIBLE CAUSE | SOLUTION |
Connected (red) | The battery is not | Check for poor connection to |
light is not on. | connected correctly. | battery and frame. Make sure |
(Models: |
| connection points are clean. |
| Rock clips back and forth for a | |
1200A) |
| better connection. |
CHECK (red) | Connection to battery is | Correct connection. |
light is not on. | reversed. |
|
(Models: | The battery voltage is less | Replace the battery or try |
& | ||
| than one volt. | using a manual charger to |
|
| bring above one volt. |
Indicator lights are lit | A button may have been | Make sure nothing is touching |
in an erratic manner, | pressed while the charger | the control panel, then unplug |
not explained in the | was being plugged in. | the unit and plug it in again. |
Operating Instructions. |
|
|
|
|
|
Connected (red) | Charger in abort mode. | Reset the charger by |
light is blinking. | Battery may also be | unplugging it. Select the |
(Models: | faulty. This will happen if | desired CHARGE RATE and |
the battery did not reach | battery type again, if | |
1200A) | full charge within 48 | necessary. |
| hours. May be due |
|
| to a very large battery |
|
| or a bank of batteries |
|
| requiring more power |
|
| than the charger can |
|
| deliver in 48 hours. |
|
• 15 •
