using the built-in BATTERY tester

OVERVIEW

This battery charger has a built-in battery tester that displays either an accurate battery voltage or an estimate of the battery’s relative charge based on the battery voltage and the Battery Council International scale.

TESTING SEQUENCE

There are four basic steps required to use the SC-7500A as a battery tester.

1.Connect the charger battery clamps to the battery. Be sure to follow all of the precautions listed under “OPERATING INSTRUCTIONS”.

2.Connectthechargerpowercordtoa120V AC 2-prong wall outlet. Again, be sure to follow all of the precautions listed under

“OPERATING INSTRUCTIONS”.

3.If necessary, press the Battery Type button until the correct type is indicated.

4.Read the voltage on the digital display or press the display mode button to set the tester to Battery % and read the battery percent.

TESTER AND CHARGER

When first turned on, the SC-7500A oper- ates only as a tester, not as a charger. To continue to use it as only a tester, avoid pressing the charge rate switch but- ton. Selecting a charge rate activates the battery charger and deactivates the tester. Pressing the CHARGE RATE button when the 75A Start LED is lit (except during the 180 second cool down) will shut off the charger and activate the tester.

POWER-UP IDLE TIME LIMIT

If no switch button is pressed within ten minutes after the battery is first powered up, the charger will automatically switch from tester to charger, if a battery is connected. In that case, the battery will be set for the 2A charge rate and 12V regular battery type.

TESTER WITHOUT TIME LIMIT

If either the Display Mode or Bat- tery Type button is pressed within the first ten minutes after the battery is

powered up, the battery will remain a tester (not a charger) indefinitely, unless a charge rate is selected.

TESTING AFTER CHARGING

After the battery has been changed from tester to charger (by selecting a charge rate), it remains a charger. To change the battery back to a tester, press the CHARGE RATE switch until all charge rate LEDs are off.

TESTER STATUS LEDs

When the SC-7500A is operating as a battery tester, the status LEDs light under the following conditions:

The CHARGED (green) LED will light if a charged battery is tested.

The CHARGING (yellow) LED does not light in the battery test mode.

The CHECK (red) LED lights unless a properly connected battery is detected.

When the tester display mode is set to voltage, the CHARGED and CHARG- ING LEDs won't light.

INITIAL PERCENT CALCULATION When a battery % is calculated for the first time after connecting a battery, the digital display will show three dashes (“---”) for a period as long as several seconds while the tester analyzes the battery.

NOTES FOR TESTING BATTERY %

A recently charged battery could have a temporarily high voltage due to what is known as “surface charge”. The voltage of such a battery will gradually drop during the period immediately after the charging system is disengaged. Consequently, the tester could display inconsistent values for such a battery. For a more accurate reading, the surface charge should be removed by temporarily creating a load on the battery, such as by turning on lights or other accessories.

The battery % ranges from 0 to 100.

The battery tester is only designed to test batteries. Testing a device with a rapidly changing voltage could yield unexpected or inaccurate results.

11

Page 11
Image 11
Schumacher SC-7500A operating instructions Using the built-in Battery tester