Schumacher SSC-1000A owner manual Operating Instructions, Charging Battery in the Vehicle

OPERATING INSTRUCTIONS

IMPORTANT: Follow all safety instructions and precautions when charging your battery. Wear complete eye protection and clothing protection. Charge your battery in a well-ventilated area.

CHARGING BATTERY IN THE VEHICLE:

1.Avoid personal injury by keeping clear of fan blades, belts, pulleys and other engine parts.

2.Avoid damaging the charger by keeping the power cord and output cords away from the hood, door or moving engine parts.

3.Note the polarity of the battery posts by checking the identification marks on the battery: POSITIVE (POS, P or +) and NEGATIVE (NEG, N or -). The positive post is usually larger than the negative post.

4.Identify which battery post is grounded or connected to the chassis. THIS IS NORMALLY THE NEGATIVE POST.

NEGATIVE GROUNDED SYSTEM

5.Connecting to a negative- grounded system: Connect the red (POSITIVE) output clamp to the POSITIVE post of the battery. Rock and twist the clamp back and forth to be sure a solid electrical connection is made. Then connect the black (NEGATIVE) output clamp to a

heavy, unpainted metal part of the chassis or engine block, away from the battery (see figure above). DO NOT connect clamp to negative battery post, carburetor, and fuel line or sheet metal part.

Connecting to a positive-grounded

system: Connect the black (NEGA- TIVE) output clamp to the NEGA- TIVE post of the battery. Rock and twist the clamp back and forth to be sure a solid electrical connection is made. Then connect the red (POSI- TIVE) output clamp to a heavy, unpainted metal part of the chassis or engine block, away from the battery. DO NOT connect clamp to positive battery post, carburetor, and fuel line or sheet metal part.

6.Plug power cord into an AC outlet. The charger will be set to the Tester Mode for REGULAR battery type.

7.Press the appropriate control buttons to select the desired charge rate and battery type. The CHARGING (yellow) LED should light and the charging process should start. If the CHECK (red) LED is on, check for correct cable connections.

8.To disconnect the charger, unplug its power cord before attempting to disconnect the output clamps. Then, standing away from the battery, remove the output clamp from the chassis or engine block. Finally, remove the output clamp from the battery post.

9.Clean and store the charger in a dry location.

6