Sea Frost Bait Freezer manual Thermostat Operation

Thermostat Operation

The thermostat is pre-set and locked at the factory. When locked the keypad is disabled and changes to the settings cannot be made. To change the settings the lockout switch must be placed in the unlock position.

To access the lockout switch:

1.Switch off the power.

2.Remove the four screws and cover.

3.Slide the lockout switch to the right to the unlock position.

4.Replace the cover.

5.Re-power the system.

6.To program refer to table below.

Step	Display	Description
1	F or C	Fahrenheit or Celsius Scale
		Press the set key once to access the Fahrenheit / Celsius
		scale. The display will show the current status, either F for
		degrees Fahrenheit or C for degrees Celsius. The
		thermostat has been pre-set at the factory for Fahrenheit.
		Press the up or down arrow key to choose between the F
		and C.
2	S1 (blinking)	Setpoint Temperature
		Press the set key again to access the setpoint. The display
		will show the current set point. The setpoint has been pre-
		set to 0 degrees F. Press either the up or down arrow key
		to change the setpoint to the desired temperature.
3	DIF 1 (blinking)	Differential Temperature
		Press the set key again to access the differential. The
		display will show the current differential. The differential
		temperature has been pre-set at 5 degrees F. Press either
		the up or down arrow key to increase or decrease the
		differential setting.
4	C1 / H1	Cooling or Heating Mode
		Press the set key again to access the heating or cooling
		mode. The display will show the current mode. C1 for
		cooling or H1 for heating. The Thermostat has been pre-
		set for C1. Do not change this setting. The BF does not
		work in heat mode. Press the set key once more and
		programming is complete.

Note: Pressing the set key accepts the setting and brings you to the next step. You must push the set key through all steps to return to the temperature display to allow the compressor to operate.

6