24 | Cheetah 4LP FC Installation Guide, Rev. B |
Drive
Front
Pin 1
J6
Reserved
Port A Bypass LED [1]
Port B Bypass LED [1]
Fault LED [1]
Reserved
Active LED [2]
+5V
Active LED [1]
Ground [3]
[1]The drive has a 2.2k ohm resistor in series with this LED driver. Connect the minus side of an external
[2]An external current limiting resistor is required when connecting an LED to this pin. The minus side of the resistor/LED combination is connected to this pin. Connect the plus side to +5V. This pin con- nects in parallel with the signal of the same name in the J1 interface connector.
[3]Jumper storage location is across pins 2 and 4 (horizontally).
