Seagate ST9160823ASG, ST980813ASG, ST9200420ASG, ST9120823AS manual Set Features command values

4 Ultra DMA mode 4 is supported.

8Ultra DMA mode 0 is currently active.

9Ultra DMA mode 1 is currently active.

10Ultra DMA mode 2 is currently active.

11Ultra DMA mode 3 is currently active.

12Ultra DMA mode 4 is currently active.

13Ultra DMA mode 5 is currently active.

Bit Word 93

131 = 80-conductor cable detected, CBLID above VIH 0 = 40-conductor cable detected, CBLID below VIL

4.3.2Set Features command

This command controls the implementation of various features that the drive supports. When the drive receives this command, it sets BSY, checks the contents of the Features register, clears BSY and generates an inter- rupt. If the value in the register does not represent a feature that the drive supports, the command is aborted. Power-on default has the read look-ahead and write caching features enabled. The acceptable values for the Features register are defined as follows:

Table 8: Set Features command values

02H	Enable write cache (default).
03H	Set transfer mode (based on value in Sector Count register).
	Sector Count register values:
	00H	Set PIO mode to default (PIO mode 2).
	01H	Set PIO mode to default and disable IORDY (PIO mode 2).
	08H	PIO mode 0
	09H	PIO mode 1
	0AH	PIO mode 2
	0BH	PIO mode 3
	0CH	PIO mode 4 (default)
	20H	Multiword DMA mode 0
	21H	Multiword DMA mode 1
	22H	Multiword DMA mode 2
	40H	Ultra DMA mode 0
	41H	Ultra DMA mode 1
	42H	Ultra DMA mode 2
	43H	Ultra DMA mode 3
	44H	Ultra DMA mode 4
	45H	Ultra DMA mode 5
41H	Enable the Free Fall Protection feature (default on ST9160823ASG and ST980813ASG models)
	(C1H below disables the Free Fall Protection feature)
55H	Disable read look-ahead (read cache) feature.
82H	Disable write cache
AAH	Enable read look-ahead (read cache) feature (default).

30 Momentus 7200.2 SATA Product Manual, Rev. E