Seagate ST94813AS, ST98823AS, ST96812AS Reliability, Agency certification, Safety certification

2.13	Reliability
Measurement type		Specification
Nonrecoverable read errors		1 per 1014 bits read, max.
Mean time between failures		330,000 power-on hours
		At nominal power, 25°C ambient temperature.
		Max case temperature: 65°C at the case measurement location shown in Figure
		5.
Load/Unload (U/UL)
25°C, 50% relative humidity		600,000 software-controlled power on/off cycles
		20,000 hard power on/off cycles
32°C, 80% relative humidity		600,000 software-controlled power on/off cycles
5°C, 80% relative humidity		20,000 hard power on/off cycles
5°C, 10% relative humidity
55°C, 16% relative humidity
Service Life		5 years
Warranty		5 years on distribution units.
		To determine the warranty for a specific drive, use a web browser to access the
		following web page:
		www.seagate.com/support/service/
		From this page, click on the “Verify Your Warranty” link. You will be asked to pro-
		vide the drive serial number, model number (or part number) and country of pur-
		chase. The system will display the warranty information for your drive.

2.14Agency certification

2.14.1Safety certification

The drives are recognized in accordance with UL 1950 and CSA C22.2 (950) and meet all applicable sections of IEC950 and EN 60950 as tested by TUV North America.

2.14.2Electromagnetic compatibility

Hard drives that display the CE mark comply with the European Union (EU) requirements specified in the Elec- tromagnetic Compatibility Directive (89/336/EEC). Testing is performed to the levels specified by the product standards for Information Technology Equipment (ITE). Emission levels are defined by EN 55022, Class B and the immunity levels are defined by EN 55024.

Seagate uses an independent laboratory to confirm compliance with the EC directives specified in the previous paragraph. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports. Computer manufacturers and system integrators should confirm EMC compliance and provide CE marking for their products.

14 Momentus 5400.2 SATA Product Manual, Rev. C