Seagate ST96812SB, ST98823SB, ST94813SB, ST9120821SB, ST9100824SB manual Environmental specifications

2.9.3Conducted noise

Input noise ripple is measured at the host system power supply across an equivalent 15-ohm resistive load on the +5 volt line.

Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave injected noise at up to 10 MHz.

Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current.

2.9.4Voltage tolerance

Voltage tolerance (including noise):

5V ± 5%

2.10Environmental specifications

2.10.1Ambient temperature

Ambient temperature is defined as the temperature of the environment immediately surrounding the drive. Actual drive case temperature should not exceed 65°C (149°F) within the operating ambient conditions.

Above 1,000 feet (305 meters), the maximum temperature is derated linearly by 1°C every 1000 feet.

Operating:	5° to 40°C (41° to 104°F)
Nonoperating:	–40° to 70°C (–40° to 158°F)

2.10.2Temperature gradient

Operating	20°C per hour (68°F per hour max), without condensation
Nonoperating	30°C per hour (86°F per hour max), without condensation

2.10.3Humidity

2.10.3.1Relative humidity

Operating	5% to 90% noncondensing (30% per hour max)
Nonoperating	5% to 95% noncondensing (30% per hour max)

2.10.3.2Wet bulb temperature

Operating	30°C	(86°F max)
Nonoperating	40°C	(104°F max)

2.10.4Altitude

Operating	–304.8 m to 3,048 m (–1,000 ft to 10,000+ ft)
Nonoperating	–304.8 m to 12,192 m (–1,000 ft to 40,000+ ft)

10 Momentus 5400.2 SATA Blade Server Product Manual, Rev. B