Seagate ST9600205FC, ST9900805FC manual Start/stop time, Prefetch/multi-segmented cache control

5.2.2Format command execution time (minutes)

	ST9900805FC	ST9600205FC	ST9450405FC	ST9300605FC
Maximum (with verify)	234	156	117	78
Maximum (without verify)	116	75	58	36

5.2.3	General performance characteristics
Sustainable disk transfer rate*:
Data buffer to/from disc media (one 512-byte logical block)*		1.00 to 1.91 Gb/s
Sustained transfer rate		89 to 160 Mib/s **
		93 to 168 MB/s
Fibre Channel Interface maximum instantaneous transfer rate		800MB/s* per port
		(dual port = 1600MB/s*)
Logical block sizes
Default is 512-byte data blocks
Sector sizes variable to 512, 520, 524 and 528 bytes.
Read/write consecutive sectors on a track		Yes
Flaw reallocation performance impact (for flaws reallocated at format time		Negligible
using the spare sectors per sparing zone reallocation scheme.)

*Assumes no errors and no relocated logical blocks. Rate measured from the start of the first logical block transfer to or from the host.

** MiB/s x 1.048 = MB/s

5.3Start/stop time

If the Motor Start option is disabled, the drive becomes ready within 20 seconds after DC power is applied. If a recoverable error condition is detected during the start sequence, the drive executes a recovery procedure and the time to become ready may exceed 20 seconds. During spin up to ready time, the drive responds to some commands over the FC interface in less than 3 seconds after application of power. Stop time is 30 seconds (maximum) from removal of DC power.

If the Motor Start option is enabled, the internal controller accepts the commands listed in the Fibre Channel Interface Manual less than 3 seconds after DC power has been applied. After the Motor Start command has been received, the drive becomes ready for normal operations within 20 seconds (excluding the error recovery procedure). The Motor Start command can also be used to command the drive to stop the spindle.

There is no power control switch on the drive.

5.4Prefetch/multi-segmented cache control

The drive provides a prefetch (read look-ahead) and multi-segmented cache control algorithms that in many cases can enhance system performance. Cache refers to the drive buffer storage space when it is used in cache operations. To select this feature, the host sends the Mode Select command with the proper values in the applicable bytes in page 08h. Prefetch and cache operations are independent features from the standpoint that each is enabled and disabled independently using the Mode Select command; however, in actual opera- tion, the prefetch feature overlaps cache operation somewhat as described in sections 5.5.1 and 5.5.2.

All default cache and prefetch mode parameter values (Mode Page 08h) for standard OEM versions of this drive family are given in Section 10.3.2

Savvio 10K.5 FC Product Manual, Rev. D 11