Cheetah 4LP Installation Guide, Rev. B | 43 |
W/WD drives
Setting the SCSI ID jumpers
Use the J6 jumper block to set the SCSI ID (Figure 11). To change the SCSI ID, install jumpers on the appropriate pins as shown in the illustration. Optional connections to switching cir- cuits in host equipment are provided on J1 auxiliary to set the SCSI ID (see Figure 12).
Jumper Plug 
J2
(enlarged to
show detail)
Pin 1
End
J6 [1] | Pin 1 | |
|
|
|
|
|
|
SCSI ID = 0 (default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
J6
Note:
[1]Do not remove cover from pins 13 through 20 (darkened area).
