TROUBLE SHOOTING GUIDE
PROBLEM | CAUSE |
| SOLUTION |
| ||
|
|
|
| |||
The LED Indicator does not light | The power cord is not plugged into | Plug cord into wall outlet. |
| |||
when the main power switch is | the wall outlet. |
|
|
|
| |
turned on. |
|
|
|
|
| |
The main fuse is blown. | Replace fuse on rear of machine. | |||||
| ||||||
|
|
| ||||
| The main circuit breaker is tripped. | Reset the main circuit breaker at the | ||||
|
| service panel. |
|
| ||
|
|
| ||||
Pouch Board is not drawn in by the | The pouch board is too thick for the | Change the nip setting up to the next | ||||
machine. The motor is making a | chosen nip setting. | or correct thickness. |
| |||
louder humming noise and/or it is |
|
|
|
|
| |
Boards of another make are being | Use only ProSEAL Pouch Boards. | |||||
stalling. Only after pushing very | ||||||
hard, the board is accepted. | used. | Use of other boards will void your | ||||
|
| warranty. |
|
|
| |
|
|
|
|
|
| |
The quality of the lamination is poor: | The roller temperature is too low. | Contract | your | Technical | Service | |
silvery areas on dark surfaces are |
| Representative. |
|
| ||
visible, or the edges of the image are |
|
|
|
|
| |
The roller pressure is too low. | Change the nip setting down to the | |||||
not sealed well. | ||||||
| next thickness. |
|
| |||
|
|
|
| |||
|
|
|
|
|
| |
The quality of the lamination is poor: | The roller temperature is too high. | Contact | your | Technical | Service | |
especially laminated Inkjet prints |
| Representative. |
|
| ||
show bubbles. |
|
|
|
|
| |
|
|
|
|
|
| |
Only one side of the Pouch Board or | The rollers are not even or parallel. | Contact | your | Technical | Service | |
Flexible Pouch is coming out fully |
| Representative. |
|
| ||
laminated. |
|
|
|
|
| |
|
|
|
|
|
| |
Technical Service
If the machine does not reach temperature or you do not get the results you desire, please contact your Technical Service Representative (see rear cover). When calling for Technical Service, please have Laminator Serial Number (listed on the ratings label) available. The ratings label is located on the rear side of the laminator.
Servicing and replacement parts
Service and maintenance must be performed fully in accordance with the instructions. Servicing by any unauthorized technician voids the warranty. A service technician must use replacement parts specified by SEAL Graphics.
NOTE! Service Technicians must perform safety checks after completing any service or repairs to the laminator.
ProSEAL® 44 Pouch Board Laminator
13
