CLEANING YOUR LAMINATOR
Cleaning the Outside of the Laminator:
CAUTION! Disconnect the laminator from the power supply before cleaning.
The laminator may be cleaned with a
Do not use an abrasive cleaner, which can damage the painted surfaces.
Do not allow water or liquids to enter the electrical circuits, which may cause personal injury and/or damage the equipment when power is applied.
Cleaning the Rollers
The laminating rollers of your ProSEAL should be periodically cleaned of adhesive build up that might occur during normal operation.
IMPORTANT! Clean the laminating rollers to prevent adhesive
When laminating, a small amount of adhesive will squeeze out between the laminate films and onto the top and bottom rollers. This residue accumulates through normal use and can be easily cleaned off the rollers.
Using a Cleaning Board:
1.A new sheet of 3/16” foam board may be used to clean the rollers. Simply run the new board through the machine to remove any built up adhesive.
1.Turn on the unit. Once the machine has reached process temperature set the Control Knob to 3/16" (5mm).
2.Slowly insert the Cleaning Board into the inlet opening. Ensure that the board enters centered and straight. A gentle push may be required to start the board into the machine. Hold the edges of the board until it is engaged in the unit and the laminator begins pulling it on its own.
3.The board will feed through the laminator and automatically exit at the rear of the unit.
CAUTION! THE BOARD WILL BE HOT! Allow the board to lie flat while cooling.
ProSEAL® 44 Pouch Board Laminator
12
