Sears 113.206930, 113.20680 manual Sharpening Cutter Blades, Weaken, Newblade

The normal position of guard {at REST) when fence is

Stati0nedat MAXIMUM WIDTH OF CUT; is shown as

........	•	NEVER	ROTATE GUARD B		EY	O	ND
postlon	A
POSTION"B"		BECAUSE		THIS WOULD EXERT EX-
CESSIVE	TENSION		ON	SPRING WHICH COULD
WEAKEN	OR	BREAK		IT,

Check Operation of GUARD and SPRING.

1:_ With fence in MAXIMUM WIDTH OF CUT position, pass a piece of 1/4 in. thick wood on edge (jointing position) over cutterhead.

2.The guard should return a_tomatically to its REST

position against the fence when free of the wood.

3.If guard does not return to its REST position, remove cotter pin from pivot pin and remove guard. Check

pivot pi_n and hole.., make sure there are no burrs, rust, or other foreign matter.

4.Apply a few drops of SAE No. 20 or No. 30 engine 0il to pivot pin.

5.Replace guard and cotter p_n.

If guard still does not return to its REST position, con- sult your local Sears Retail Store before using the

jointer-planer,

, i =ll i ,i i , i i ii

SHARPENING: CUTTER BLADES

The blades can be honed individually with an ordinary

oilstone,

Make sure your oilstone is not worn in the center. It must be flat.

Be sure to remove the burr on the flat side.

' OF

_.L,,

POSITION "B"/ /

If the blades are nicked, they must be replaced or re-

ground; They can be reground several: times until they become 9/16 in. wide. Never install reground blades less than 9/16 in. wide.

Have your		knives	reground	by someone	who is corn *	11116 IN.
petent.	Look	in	the "YeIow	Pages" of	you r telephone
directory	...	see	"Sharpening	Services"

NEWBLADE

24