b. Before tightening fence lock knob, hold fence
down on outfeed table so it does not rock.
c. 90° Fence Stop positions fence square to tables.
To tilt fence, loosen the two knobs .and pull the
sto;p out. Tilt to desired angle and tighten both
knobs.
d. To set fence at 90° to tables, loosen the two
knobs, tilt fence so t;qe stop springs back iSto
place. Tilt fence back so the stop rests on the
. . :.... iiiiiitJ:IH111111
.FENCE TILT SCALE. indicates the angle of the
fence to the tables. When the 90° fence stop is cor-
rectly adjusted, the fence wilt be 90 ° to the table and
the scale wi]l read 90 ° .
To check for squareness, place an accurate square on
infeed table and check fence while locked at 90 °
position. MAKE SURE 90 ° STOP IS AGAINST
SLIDE BRACKET.
if fence is not square to table;
a, Slightly loosen fence lock knob and guard lock
knob.
:: table: ahcl tighten both knobs,
e. 45° Fence Stop positions the fence at 45° to the
tables.
f. To tilt fence to 45 ° loosen the two knobs, pull
90° stop out, tilt fence so the 45 ° stop rests on the
table

g. Hold fence down on outfeed table and tighten the

two knobs.

i!i_ FENCE TILT
900 FENCE
STOP _

SCALE

FENCE
FACE

SQUARE

CUTTER

GUARD

INFEED

TABLE

b_
c.
d,
Loosen 90° stop screw with small screwdriver and
turn knurled sleeve which will cause fence to tilt.
Turn sleeve in either direction until fence issquare
with infeed table.
NOTE: If you cannot square fence by turning
knurled sleeve, loosen three screws "A" and adjust
fence square to table.

Tighten 90° stop tockscrew and both fence lock

knobs.

If 90 ° reading on tilt scale does not line up with
top surface of the slide bracket, _oosen screws
holding scale and move it . . . tighten screws.

45° STOP

KNURLED

45° STOP \
90°STOP
A
SCALE
ADJUSTING
SCREW
•_LOCKSCREW
TILT
/SCALE
_90 ° STOP
•,._SCALE
-_ ADJUSTING
_SCREW
1
SLIDE
BRACKET
900STOpt3