ASSEMBLY
UNPACKING
This product requires assembly
Carefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included.
WARNING: This new product has been shipped in a partially assembled condition as described below. Carefully check the packing list below to ensure all items are included in the package; the packing list describes all loose items that are not assembled to the product as shipped. Do not operate the product if any packing list items are already assembled to your product when you unpack it. Call the customer service number below for assistance. Operation of a product that may have been improperly preas - sembled could result in serious personal injury.
Inspect the product carefully to make sure no breakage or damage occurred during shipping.
Do not discard the packing material until you have care - fully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
PACKING LIST
Electric blower
Blower tube
Mulcher tubes
Bag
Operator’s Manual
WARNING: If any parts are damaged or missing, do not operate this product until the parts are replaced. Failure to heed this warning could result in serious personal injury.
WARNING: Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury.
ASSEMBLE AS A MULCHER
See Figure 3, page i and ii.
1.Slide the front and rear mulcher tubes together until the lock button engages. (See fig 3)
2.Pull the lock button forward to disengage the gate. Hold the gate open. (See fig 3.1)
3.Insert the “wedged” end clip of the mulcher tube into the rear clip. (See fig 3.2). Push the “hooked” end clip of the mulcher tube into the front clip. (See fig 3.3). Press the lock button back to engage the mulcher tube. (See fig 3.4)
4.To remove mulcher tubes, follow the steps (3) (2) (1).
5.Insert the bag adaptor into the blower outlet. Lock the bag adaptor with the lock button. To remove the bag, simply press lock button and remove bag. (see Fig.5).
NOTE: It may be necessary to remove the blower tube or mulcher tubes to clear a blocked tube or impeller.
WARNING: To prevent serious personal injury, make sure the switch is in the OFF position, it is unplugged, and the impellers have stopped before attaching or removing tubes.
ASSEMBLE AS A BLOWER
See Figure 4 page i and ii.
1.Slide blower tube forward until the notched areas on the blower housing click into the slots on the tube.
2.Insert the concentrator nozzle onto the regular nozzle to lock. (Concentrator nozzle is used to increase air flow in tight areas: flower beds. under decks, etc.).
NOTE: Blower will not run until gate is closed and locked.
INSTALLING BAG WITH SHOULDER HAR- NESS
See Figure 5 page i and ii.
While standing in the operating position adjust the length to fit the operator’s size. Pull the tab to lengthen, pull the strap to shorten.
9 - English
