Model 139.53779
To comply with FCC rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO
OTHER USER SERVICEABLE PARTS.
The 53000 Series remote control (with green battery test light) works only with door openers and light controls having a green "SRT" button and green indicator light.
Instructions are given below for programming your opener to match the remote control's code. The additional remote control buttons
can also activate other garage door openers and/or light controls. (Instructions for programming light products are included with those accessories.)
Owner's Manual
Model 139.53759
Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the wall push button(s) or remote control(s).
A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted.
53000 Series Garage Door Openers
(With Green "SRT" Button and Green Indicator Light)
PROGRAM THE OPENER TO ACCEPT
THE REMOTE CONTROL CODE
Select a remote control push button to operate the receiver. The large button is recommended for use with the garage door opener.
1.Press and HOLD the selected remote control push button, Figure 1.
2.Then press and release the green "SRT" button on the right side panel of the opener in Figure 2. The opener light will flash once.
Now the opener will operate when the remote control push button is pressed.
If you release the remote control push button before the opener light flashes, the opener has not accepted the code.
To Change the Selected Push Button On the Same Remote Control
If you decide to use a different remote control button than originally programmed into the opener, you need to erase a//the learned codes and reprogram each remote control used to operate the garage door opener.
To Erase All Remote Control Codes
•Press and hold the green "SRT" button on the opener panel until the indicator light turns off
(about 6 seconds). AIIthe codes the opener has learned will be erased.
•To reprogram, repeat Steps 1,2 and 3 for each remote control in use.
Figure 1 | Model 53759 |
/
Select a remote controt push button to operate opener
Model 53779
Figure 2 | Garage Door Opener |
| (With Green "SRT" Button) |
Green indicator
"SRT" Light
Button
Code programming instructions are also located on the opener panel.
Replacement Parts:
12 Volt battery- 10A14; Compact remote control case, cover and Velcro strip (circuit board not included)
| © 1994, Sears Roebuck & Company |
|
114A1462D | All Rights Reserved | Printed in Mexico |