SAFETY INSTRUCTIONS cont.
SAFETY RULES FOR BATTERY CHARGER cont.
10.Do not disassemble charger. Take it to a qualified service dealer
when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
11.Disconnect charger from the power supply when not in use. This will reduce the risk of electric shock or damage if metal items should fall into the opening in the charger. It also will help prevent damage during a power surge.
12.Risk of electric shock. Do not touch
13.Save these instructions. Refer to them frequently and use them to instruct others who may use this tool. If you loan someone this tool, also loan them these instructions to prevent misuse of the product and possible injury.
ADDITIONAL RULES FOR SAFE OPERATION
!WARNING: BE SURE to read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire \ and / or serious personal injury.
1.ALWAYS wear safety glasses or eye shields when using this tool. Everyday eyeglasses have only
2.PROTECT your lungs. Wear a face mask, dust mask or respirator if the operation is dusty.
3.PROTECT your hearing. Wear appropriate personal hearing protection during use. Under some conditions noise from this product may contribute to hearing loss.
4.ALL VISITORS AND BYSTANDERS MUST wear the same safety equipment that the operator of the tool wears.
5.ALWAYS check the tool for damaged parts. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine if it will operate properly and perform its intended function. Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tool’s operation. A guard or other part that is damaged should be properly repaired or replaced at a Sears Service center.
6.SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instruct others who may use this tool. If someone borrows this tool, make sure they have these instructions also.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
10
UNPACKING (Fig. 1)
1.The trimmer comes assembled except for the guard, edge guide wheels and auxiliary handle, which must be attached.
2.Remove the trimmer, auxiliary handle, safety guard, edge guide wheels, box containing the battery pack and charger from the carton and inspect your trimmer.
3.Do not discard box or packing material until all parts are examined.
!WARNING: If any part of the trimmer is missing or damaged, do not install the battery pack into the trimmer until the damaged part is repaired or replaced.
Fig. 1
Knob and Screw to Loosen or Tighten Handle (This knob comes attached to the auxiliary handle and mounts on this [right] side)
Battery Charger
Trimmer | Auxiliary Handle |
Battery Pack
Edge Guide Wheels
Safety Guard
11
