Sears 200.71219 Charging Battery Removed From The Vehicle, output clamp to the free end of the

Charging Battery Removed From The Vehicle:

POSITIVENEGATIVE

BATTERY CHARGER

4. Position yourself as far away from

the battery as possible, and then

connect the black (NEGATIVE)

output clamp to the free end of the

cable.

BATTERY

24", 6 GAUGE CABLE

POWER CORD

5.	Select the desired charge rate and
	battery type: 2A, 12V or 4A, 6V.
6.	Plug the power cord into an AC 110V
	electrical wall outlet.
7.	Press the appropriate control buttons

TO

GROUNDED

POWER

OUTLET

1.Note the polarity of the battery posts by checking the identification marks on the battery: POSITIVE (POS, P or +) and NEGATIVE (NEG, N or -).

The positive post is usually larger than the negative post.

2.Attach at least a 24-inch-long, 6- gauge (AWG), insulated battery ca- ble to NEGATIVE (NEG, N or -) bat- tery post. Rock and twist the clamp back and forth to be sure a solid electrical connection is made.

3.Connect the red (POSITIVE) output clamp to the POSITIVE battery post. Rock and twist the clamp back and forth to be sure a solid electrical con- nection is made.

to select the desired charge rate

and battery type. The CHARGING

(yellow) LED should light and the

charging process should start. If the

CHECK (red) LED is on, check for

correct cable connections.

8. To disconnect the charger, unplug

its power cord before attempting

to disconnect the charger clamps.

Then, standing away from the bat-

tery, remove the output clamp from

the NEGATIVE battery post. Finally,

remove the output clamp from the

POSITIVE battery post.

9. Clean and store the charger in a dry

location.

IMPORTANT: Follow all safety instruc- tions and precautions when charging your battery. Wear complete eye protec- tion and clothing protection. Charge your battery in a well-ventilated area.