Sears 200.71495 owner manual Problem Alarm is On, Troubleshooting

9.troubleshooting

Problem: Alarm is On

REASON						SOLUTION
Display shows			. Device has a short			Cycle inverter power OFF and ON.
		SC
circuit or demands					too much surge	If problem persists, use a larger inverter
power.
						or a smaller device
						Remove defective device.
						Call 1-800-SEARS-64 (1-800-732-7764)
						for troubleshooting assistance.
Display shows					. 12 Volt battery is	Recharge/replace low battery.
		Lo b
too low.
Display shows Voltage in between						12 Volt battery is low.
10.5 and 11.0 Volts.						Recharge/replace low battery.
						Inverter will automatically shut off after
						battery voltage reaches 10.5 volts.
Display shows				. DC Voltage in is		If in a vehicle, repair/replace the alterna-
	Hi b
too high.						tor or charging system.
						Use a properly sized and rated 12 Volt
						battery.
						If input voltage returns to 15 volts or less,
						the inverter will automatically restart.
Display shows	HiP. Device demands					Cycle inverter power OFF and ON.
more than 750	Watts continuous					If problem persists, use a larger inverter
power.
						or a smaller device.
Display shows				. Inverter is too hot.		Increase ventilation to inverter.
		HoT
						Move inverter to a cooler area.
						Reduce the power consumption of the
						device.
						Inverter will automatically reset after
						cooling.
Problem: Inverter Does Not Turn On
REASON						SOLUTION
Poor contact at terminals.						Unplug and reinsert Power Inverter 750.
Fuse is blown.						A blown fuse is usually caused by re-
						verse polarity or a short circuit within the
						inverter. The fuse is not user replaceable.
Inverter may be defective.						Call 1-800-SEARS-64 (1-800-732-7764)
						for troubleshooting assistance.
						• 6 •