Sears 200.71987 manual 12V DC Electrical Device Run-TimeChart, Appliance Type, Estimated Power

12V DC Electrical Device Run-Time Chart

Appliance Type	Estimated Power	Estimated
		Time*
Fluorescent Lights, Cellular Phones	4 Watts	40 Hours
Radios, Depth Finders, Fans	9 Watts	21 Hours
Camcorders, DVD Players, Spotlights	15 Watts	12 Hours
Electrical Tools, Bilge Pumps	24 Watts	7 Hours
Electric Coolers	48 Watts	3 Hours
Air Compressors, Car Vacuums	80 Watts	1.5 Hour

*NOTE: Estimated run-times. Actual time may vary. Times are based on the internal battery being new, fully charged and operated at room tem- perature.

7.using the usb port

The USB port on the 950 provides up to 500mA at 5VDC

7.1Turn the JUMP START ON/OFF switch to the ON position.

7.2Plug the device into the USB port on the front panel of the 950.

7.3Turn USB device ON.

7.4Reverse these steps when finished using the USB port.

8.using the built-in light

8.1Position the 950 on a flat, stable surface near the intended work area.

8.2Push the power switch to the LIGHT position. The light will turn on and illuminate your work area.

NOTE: With a fully charged internal battery, the built-in light should pro- vide 18 to 30 hours of continuous, useful light.

8.3Push power switch to the OFF position when work is completed.

8.4Charge the 950 as soon as possible after using the built-in light.

9.internal battery replacement

The 950 is equipped with a built in door, located on the back of the unit, to make replacing the internal battery easy and efficient.

To order a replacement battery, call: 1-800-SEARS-64

9.1Be sure that all switches are in the OFF position.

9.2Remove clamps from storage pegs on the back of the 950.

9.3Remove eight screws from the door.

9.4Slide door out.

•5 •