9.internal battery replacement
The 1150 is equipped with a built in door, located on the back of the unit, to make replacing the internal battery easy and efficient.
To order a replacement battery, call:
9.1Be sure that all switches are in the OFF position.
9.2Remove clamps from storage pegs on the back of the 1150.
9.3Remove eight screws from the door.
9.4Slide door out.
9.5Remove the negative (first) and positive nuts and bolts securing the cable to the battery.
9.6Push cables to the side and carefully slide battery out of the 1150.
9.7Reverse steps for assembly. Make sure that the nuts and bolts securing the cables are tight.
10.using the air compressor
CAUTION: Read instructions of the product being inflated before using the compressor. Avoid over inflation, do not exceed the manufacturer’s recommended pressures. Do not leave the air compressor unattended during use.
10.1Remove the air compressor hose from the storage compartment in the back of the Portable Power 1150. Install adapters as necessary.
10.2Attach the air compressor hose to the product or accessory to be inflated by flipping down the lever.
10.3Place the Inverter/Compressor Switch in the compressor position and inflate product.
10.4When the product is inflated to the proper air pressure (using the air com- pressor gauge) place the Inverter/Compressor Switch in the OFF position and remove the hose.
10.5Do not run for more than 10 minutes maximum at a time. Allow the 1150 to cool down for 10 minutes before using again.
NOTE: If the compressor overheats, the
NOTE: The air compressor is rated for 150 PSI.
10.6Estimated Time for Inflating
Vehicle Tires 13” to 16” | 6 to 24 minutes |
Bike Tire | 1 to 3 minutes |
Sports Balls | 30 seconds |
Use the air compressor gauge to ensure the proper pressure has been reached. Do not over inflate.
• 7 •
