Filter Installation And Replacement, Maintenance, Filters

All wiring connections must comply with local codes and the unit

must be properly grounded.

1.Make sure box connector is secure.

2.Refer to FIGURE 8. Make wiring connections.

3.Replace electrical box cover and secure with screw.

OR REPLACEMENT

1.Depress sides of light diffuser until tabs of diShlser disengage from slots in hood. Remove diffuser.

2.Install (2) 40 watt maximum,Type A-15 appliance bulbs.

3.Replace difuser in hood by depressing sides and engaging tabs in slots in hood.

FILTER INSTALLATION

AND REPLACEMENT

1.For ducted operation, install the aluminum mesh filter. For non-

duct operation, install the non-ducted filter (Model 50190, sold separately).

2.Refer to FIGURE 9. The filter slides into channels at the back of

the hood,on either side of the fan compartment,and snaps under the spring clips near the front of the fan compartment.

IMPORTANT:The aluminum filter should be removed once monthly

and washed in hot detergent water. Rinse in clear, warm water and

shake off excess moisture before replacing. The fdter may also be cleaned in your dishwasher.

INA NON-DUCTED INSTALLATION:Replace filter every 3_ months as needed.

The hood should be wiped off occasionally both inside and outside

using warm water, mild dish detergent and a soft cloth. Never use

scouring powders, steel wool pads or any other abrasive cleaners which will destroy the hood's finish.

FIGURE8

FIGURE 9