Sears 274.4372859 owner manual Using Advanced Features, Placing Channels in Memory Autoprogramming

Using Advanced Features

Placing Channels in Memory (Autoprogramming)

Only channels 2-13 appear in the TV's memory when you first turn it on.

The channels available in your area must be programmed into the TV's memory when you hook up your TV. Using CHANNEL up or down allows you to scan through these channels.

You may want to add or delete a few channels if some stations have weak

signals or were off the air when the TV was programmed. Refer to the Add or Delete Channels section below.

1. Place channels	in	13	A. Hook	up	an antenna,	cable or
memory (Autoprogram)			components before			you	begin
			these steps or you will not be
			able to add channels into
	Controls	Alarm Ad	memory.
			B. Press	MENUopROG		repeatedly
			to select the Setup Menu and
			highlight		Autoprogram.		This
			menu	is white.
			C. Press MOVE • to start the TV
			adding all active channels into
			memory.
			D. Wait until the TV has cycled
			through all the channels and
			returns to the original channel.
	Eabe!	_3

2. Add or delete channels	13
Controls	Alarm Ad

13

Controls Alarm Adjust _t_p _

..... "_ _'_f"_' _;!__i:_._ ,:i

Cable/Air Cab

A. Press MENUoPROG repeatedly

to select the Setup menu. This menu is white.

B. Press MOVE • to highlight Channel Memory.

C. Press MOVE • to underline the channel number.

D. Select the channel number you want to add or delete with the

number buttons.

E. Press MOVE • to add or delete

a channel (you will see Stored on the screen when added and Erased when deleted).

F.Repeat D and E for more channels.

19